PRESSFIT TECHNOLOGY
PRESSFIT TECHNOLOGY

AVAILABLE PRESSFIT PINS

0.50x0.40 mmFin 74-91 NFout 54-73 NPCB hole ∅0.60

 

 

 

 

 

0.64x0.64 mmFin <100 NFout >20 NPCB hole ∅1

0.6x1.0 mmFin 66–135 NFout 145–235 NPCB hole ∅1.25

0.6x1.5 mm

0.8x1.5 mm

PRESSFIT PIN ADVANTAGES

Higher reliability

Size difference between PCB hole and Pressfit zone leads to Pressfit deformation during insertion. Compression of a pin guarantees reliable connection.

Qualification

Pressfit pins 0.50×0.40 mm, 0.60×1.00 mm, 0.60×0.60 mm, 1.2×0.6 mm are qualified in accordance to EN 60352-5. It proved to have required contact resistance (< 0.5 mΩ), acceptable deformations and resistance to rapid temperature changes and climate sequences.

Deformation and vibrations resistance

Pin insertion doesn’t require additional soldering which means no thermal stress and no damage for components. As a result connection stays reliable under vibrations.

End-to-end supply

Reel is compact and easy to change. It fits all pin types and sizes. Compared to the bandolier pins, there is no excess material left from the end-to-end pins. No need to buy a new reel every time the pins run out: the reel is rechargeable. Only SM Contact supplies 0.4*0.5 Pressfit pins as end-to-end.

PRESSFIT EN 60352-5 QUALIFICATION

✓ ΔRc < 0.5 mΩ

*Technical reports could be presented on your request

✓ No cracks
✓ amax < 70 µm (drilled hole contour deformation)
✓ bmin > 8 µm (remaining thickness of the plating)
✓ cmax < 50 µm (outer layer deformation)

*Technical reports could be presented on your request

✓ 10 cycles
✓ −40 °C/+85 °C
✓ t1 = 30 min

*Technical reports could be presented on your request

✓ +85 °C, 16 h
✓ +25 °C/+55 °C, 90% RH/95% RH
✓ −40 °C, 2 h

*Technical reports could be presented on your request

PRESSFIT 60352-5 QUALIFICATION Press-in force
Press-in force measurement

PRESSFIT 60352-5 QUALIFICATION Temperature and humidity

Temperature and humidity recording

PRESSFIT 60352-5 QUALIFICATION Longitudinal sectioning
Longitudinal sectioning

PRESSFIT 60352-5 QUALIFICATION Transverse sectioning
Transverse sectioning